(814) 474-5200 | | Fairview, PA

News

Spray it Again, Sam!

Posted on December 12th, 2016

Light or heavy coverage, contamination, out gassing, bleed through, and surface defects are all reasons that may require you to rework a powder-coated part.

Passing Gas

Posted on October 15th, 2016

Both aluminum and iron castings can have porosity problems, but the physical properties of the aluminum make it more likely for this porosity to become an issue when the parts are powder coated.

It’s Good When I Say It’s Good!

Posted on September 16th, 2016

They say that beauty is in the eye of the beholder. When it comes to finishing, that couldn’t be truer. All finishes are like works of art, but only the customer can say that a finish is beautiful.

When the Chips Are Down…

Posted on August 2nd, 2016

As we have become more involved in architectural coatings we have seen a significant increase in the amount of aluminum extrusion we finish. Most of this material is mill finish stock length and is anywhere from 10 to 24 feet. We pre-treat and powder coat it per customer specifications, usually prior to any fabrication or cutting operations. Due to the nature of the product and its’ high visibility, superior quality is expected, and defects due to dirt or contamination are not acceptable.

Turn your imagination into reality.

Contact Us
© 2018 A Tex Finishing, All Rights Reserved.|Website by LUMINUS